Axle Shaft (Rear) Explanation

REAR AXLE SHAFT REMOVAL
1. With transmission in neutral, position vehicle on hoist.
2. Remove brake caliper with adapter and rotor.
3. Remove park brake cable (1) from support plate (2).
4. Remove brake sensor harness (1) and remove sensor (2) from support plate.
5. Remove axle retainer plate nuts.
6. Pull axle shaft (1) with support plate, bearing and seal from axle tube (2).
NOTE: Park brake cables are self adjusting and must be locked out before removal.

REAR AXLE SHAFT INSTALLATION
1. Install axle assembly (1) into the axle tube (2).
2. Install NEW axle retainer nuts and tighten to the proper specification. Refer to
SPECIFICATIONS
3. Install brake (2) and harness (1).
4. Install park brake cables (1).

WARNING: Never reuse axle retainer nuts. Used torque nuts can loosen up. Failure to follow these instruction may result in personal injury.