Door Adjustments (Front) Explanation

FONT DOOR ADJUSTMENTS

NOTES:
- For four door vehicles, it is recommended that you adjust the rear door before adjusting the front door. Refer to ADJUSTMENTS, REAR, DOOR
- Full front door shown, all others similar.
- Door adjustment measurements should be taken from stationary or welded body panels like the roof, rocker or quarter panels.
- During adjustment procedures, it is recommended that all the hinge fasteners be loosened except for the upper most fasteners. Adjustments can be made using the upper bolts to hold the door with final torque of the fasteners occurring after correct door positioning is achieved.
- A suitable body sealant should be used when removing or moving the hinges.

FRONT DOOR ADJUSTMENTS (FORE/AFT)
NOTE: Fore/aft (lateral) door adjustment is done by loosening the hinge to the door fasteners one hinge at a time and moving the door to the correct position.
1. Support the door with a suitable lifting device.
2. Loosen the upper (Fig 1) #1 and lower #4 hinge to door fasteners. Refer to HINGE, DOOR, REMOVAL or HINGE, DOOR, REMOVAL
3. Adjust the door to the correct position. Refer to GAP AND FLUSH, SPECIFICATIONS
4. Tighten the hinge to door bolts to 26 N.m (19 ft. lbs.).

FRONT DOOR ADJUSTMENTS (UP/DOWN)
NOTE: Up/down door adjustment is done by loosening hinge to the hinge pillar fasteners or the hinge to door fasteners and moving the door to the correct position.
1. Support the door with a suitable lifting device.
2. Loosen the latch striker bolts (Fig 2) #3. Refer to STRIKER, DOOR LATCH, REMOVAL or STRIKER, DOOR LATCH, REMOVAL
3. If necessary, loosen the hinge to hinge pillar fasteners (Fig 3) #2 and #3. Refer to HINGE, DOOR, REMOVAL or HINGE, DOOR, REMOVAL
4. Tighten the hinge to body fasteners to 28 N.m (21 ft. lbs.).
5. If necessary, Loosen the hinge to door fasteners (Fig 3) #1 and #4. Refer to DOOR, REMOVAL or
DOOR, REMOVAL
6. Adjust the door to the correct position. Refer to GAP AND FLUSH, SPECIFICATIONS
7. Tighten the door to hinge fasteners to 26 N.m (19 ft. lbs.).
8. Tighten the latch striker bolts (Fig 2) #3 26 N.m (19 ft. lbs.). Refer to STRIKER, DOOR LATCH, INSTALLATION or STRIKER, DOOR LATCH, INSTALLATION

FRONT DOOR ADJUSTMENTS (IN/OUT)
NOTE: In/out door adjustment is done by loosening the hinge to body fasteners one hinge at a time and moving the door to the correct position.
1. Support the door with a suitable lifting device.
2. Loosen the latch striker bolts (Fig 2) #3. Refer to STRIKER, DOOR LATCH, REMOVAL or STRIKER, DOOR LATCH, REMOVAL
3. Loosen the hinge to body fasteners (Fig 3) #2 and #3, Refer to DOOR, REMOVAL
4. Adjust the door to the correct position. Refer to GAP AND FLUSH, SPECIFICATIONS
5. Tighten the hinge to body fasteners to 28 N.m (21 ft. lbs.).
6. Tighten the latch striker bolts (Fig 2) #3 to 26 N.m (19 ft. lbs.). Refer to STRIKER, DOOR LATCH, INSTALLATION and STRIKER, DOOR LATCH, INSTALLATION